SSH Connection to Host Computer

dangerous

This document applies only to FLY host computers
If you are compiling or flashing firmware, please refer to the network connection tutorial instead of the serial connection tutorial

You can connect to the device via serial port or Wi-Fi
Please prepare MobaXterm_Personal or other SSH terminal tools in advance
Ensure that the SD card or M2WE has the corresponding host computer system flashed
If the host computer fails to boot normally, remove peripherals such as drivers, limit switches, fans, etc.!!!
Finally, connect via network to SSH for easier firmware compilation!!
If you need to compile firmware, please refer to the tutorials for connecting the host computer via Wi-Fi or Ethernet cable

Installing the System Storage Card

Ensure that the system card has the corresponding system flashed; otherwise, it will not boot

If the motherboard is properly connected to the computer, you can see the CH340 port by opening the Device Manager.

Open MobaXterm and set it up as shown below. Select the port previously seen in the Device Manager.

If everything is normal, you should see the startup screen.
After a brief wait, if the screen below appears, the system has started successfully.

If after waiting for several minutes, as shown below, there is no display on the screen, press the Enter key several times.

Please note that for the FAST system, you need to enter the username and password, and the password will not be visible.
FlyOS-FAST default username is root, default password is mellow.
Starting from version V1.3.2, the FAST system automatically logs in when connecting via serial port by double-clicking or pressing Enter twice consecutively.
The following content will appear after pressing Enter

tip

If you need to check the device IP, ensure the device is connected to an Ethernet cable or has successfully connected to WIFI. Connect to WIFI

Please log into the router's backend connected to the host computer unless you already know the host computer's IP address.
Please ensure you know the username and password of the host computer.
FlyOS-FAST default username is root, default password is mellow.
If the motherboard has already booted and is connected to the network, you can use the following method to connect to SSH.
Open MobaXterm and set it up as shown below. Fill in the IP address previously checked, which can also be viewed in the router's backend.

Note: The username entered in step 4 here is the host computer's username.

The first time connecting, a window like this will pop up; click Accept to proceed.

When prompted for a password, press Enter after entering the host computer's password.

Note: The password entered here is not visible. Press Enter directly after typing it in.

tip